shop injectors shop injectors
   Home  |  Fuel Injectors  |  Diesel Injection  |  GM Spider Injectors  |  Marine Injectors  |  Injection Pumps  |  Track Order  |  Cart  |  Checkout
shop injectors
shop injectors shop injectors
shop injectors
DODGE/CUMMINS     Diesel Fuel Injectors

DE891 Dodge Ram Remanufactured Fuel Injector
Actual appearance may vary

 

Dodge-Cummins Diesel Fuel Injectors remanufactured by Bostech have been stripped and cleaned. All O-Rings, Pintels, etc. are replaced. The fuel flow on all of our injectors is rigorously tested prior to our factory certification.

Each Bostech Fuel Injector includes both the Injector and the Seal Kit. Click Here for Installation Instructions.

Bostech factory certifications meet or exceed industry standards for fuel flow, and come with a 1-Year, Unlimited Mile Warranty.


Questions? Call 1-877-558-0996


List Price:
Our Price:
You Save:
Core Fee:

$100.00
$54.95
$45.05
$10.00

 

SPECIFICATIONS
MADE FOR:
PART NUMBERS:
YOU MAY ALSO WANT:
To install this Injector you will need
TL1-TL2 Injector Installation Brushes

 

   HOW TO INSTALL THIS INJECTOR:
Installing remanufactured fuel injectors is a fairly simple process and can be done yourself with a few basic tools and a little time. If you are not familiar with your fuel injector system, grab your vehicle's repair manual to assist along the way.
  1. Remove the air box, unless you have already upgraded your air intake system, then this step is not necessary. If you will be installing a supercharger with it, remove the air inlet temperature sensor as well. They tend to stick a little, so be patient with it.
  2. Take out the bolts holding the strut tower brace on and remove it. These bolts are generally 10 mm in size and there will be eight or so of them. A standard 10 mm torque wrench should do the trick. If they stick, use a little engine cleaner to help loosen them.
  3. Continue removing components until you reach the fuel rail. These components will include: idle air control valve, EGR, throttle position sensor, throttle cable, EGR valve, intake manifold, all hoses, electrical connectors, fuel lines and, alas, the fuel rail which houses the fuel injectors.
  4. Wiggle the fuel injectors off much like when replacing spark plugs and wires. Each one will spray some gas, so no smoking during this process. Place the new injector in place of the old on and lubricate the O-ring with some 20W engine oil. Reinstall everything and you are done.


If you're getting raw fuel to exhaust pipe:

  1. Check for open intake valves.
  2. (Bad pressure regulator)  It builds too much pressure in the fuel rails and consumes a large amount of excess gasoline.  Also, ½ gallon of fuel ends up in the oil pan.  In this case, the oil should be changed immediately.


To find the fuel leak:

  1. Remove upper intake manifold
  2. Turn the key on (but do not attempt to start the vehicle)
  3. After the fuel pump comes on, you should be able to visually identify any leaks.

 

 

shop injectors
shop injectors
shop injectors  

Shop Injectors Pages
Home Page
Contact Us
Terms of Service
Customer Service
Warranty


Shopping Cart
My Cart
Track Order
Checkout

Our Websites
Bostech Fuel
Car Parts Warehouse
Rack & Pinion Warehouse
Shop Injectors
Shop Steering Racks